I asked how to make SCI break last time and TI expert told me that I can make SCI break with GPIO control. In data sheet : SCI is low for 9.625 bit following a missing stop bit. (Start 1bit + data ...

It seems both Windows (192kHz max?) and Linux (ALSA: 384kHz) have maximum hardware audio capture sampling rates below 768kHz. When a sound recording application like Audacity is asked to capture at ...

sdhci_send_command: MMC: 1 busy timeout increasing to: 200 ms. sdhci_send_command: MMC: 1 busy timeout increasing to: 400 ms. sdhci_send_command: MMC: 1 busy timeout increasing to: 800 ms.

I want to use interconnect studio. I have read the User'sGuide.However,I was unable to access 「interconnect_studio.itg.ti.com.」 ...

I would like to copy over a default image of Linux from an SD card into the eMMC. I currently have copied U-Boot over by following this tutorial: ...

1、M3与TCAN4550的SPI通信正常：表现为读DEVICE ID正常；初始化寄存器的时候进行写后，回读与写的值比较，均通过； 2、M3与TCAN4550的SPI通信连接；TCAN4550与上位机通过CAN2.0B调试工具，，通过如下 ...

I am trying to interface with an LVDS daughter card that uses the DS90LV804TSQ LVDS buffer/repeater chips. I am wondering if the chip is unpowered, is it safe to send LVDS signals into without ...

This is my encoding channel, the code stream encoded by this channel, the general_level_idc value is 10, but this value does not comply with the h265 protocol, the decoder cannot decode correctly, how ...

So at this point, we are trying to use MCU to overwrite the current and clear the Dead Battery Mode. Could you help to support: 1. Which register to over write the charging current? Is that possible ...

We can't pull a video stream from the camera right now,We want to read the register to confirm the csirx status,Which register should we read? Can you provide a read instruction?

The ADS1248 is only specified to 105C, so it is possible you are getting issues because you are nearing (or exceeding) this rating. What exactly are the issues? Can you describe them in more detail, ...

Order of millivolts output swing to be fed into an ADC I'm using currently using TINA-TI to simulate the TIA, with the ultimate goal of producing a tangible physical version of the circuit in the ...