If you are wanting to configure a peripheral register as a DMA source or destination address, you want to use the "Manual" or "Variable/Function Name" options. Please see the explanation on the thread ...

I asked how to make SCI break last time and TI expert told me that I can make SCI break with GPIO control. In data sheet : SCI is low for 9.625 bit following a missing stop bit. (Start 1bit + data ...

It seems both Windows (192kHz max?) and Linux (ALSA: 384kHz) have maximum hardware audio capture sampling rates below 768kHz. When a sound recording application like Audacity is asked to capture at ...

sdhci_send_command: MMC: 1 busy timeout increasing to: 200 ms. sdhci_send_command: MMC: 1 busy timeout increasing to: 400 ms. sdhci_send_command: MMC: 1 busy timeout increasing to: 800 ms.

I can't download my firmware(.out) to CC2745R10 EVB with LP-XDS110 download debugger.(I chose Part number:CC2745P10 because there is no CC2745R10.) Here is a my trouble shooting. 1. Hardware Setup Set ...

I would like to copy over a default image of Linux from an SD card into the eMMC. I currently have copied U-Boot over by following this tutorial: ...

I am trying to interface with an LVDS daughter card that uses the DS90LV804TSQ LVDS buffer/repeater chips. I am wondering if the chip is unpowered, is it safe to send LVDS signals into without ...

I am designing a BMS around BQ76922 and I went through its datasheet and it doesn't specify that it have in-built ESD protection for cell measurement connections. I also went through BQ76922EVM user ...

I have a problem with running my CLA CODE when I run my program in flash. When i run thise program in RAM, i don't have these problems. Problem description: CLA TASK1 is triggered by int 6.11 (SD1).

as always thanks a lot for your great products and namely the current and voltage sensors line of products. This time we are using the INA219 on our design to measure the 24V input voltage connected ...

I try to make my own flowmeter with EVM430-FR6047 module, but when I connect the EVM430-FR6047 to the Ultrasonic Sensing Device Center (water mode), a message appears: "HID device connected, but could ...

I am using the TMS570LC4357 development board. Currently, I can successfully run the TMS570LC43x_rtiBlinky_BL_APP20020.bin using the Hercules_Ethernet_Bootloader. However, when I load my own created ...